Du-Bro Body Klip Retainer, with Rubber Attachments, for RC Cars and Trucks, 2-Pack, Lime Green

These make life so much easier since traxxas doesn’t like to give you clip retainers

I love these things they are awesome no more losing your clips in the grass or anywhere else.

After I saw this, I knew it was what I needed for my 1/10 basher truck. My wife and I both have one, and its typical to lose a few clips every time we would run a few batteries thru .....So I ordered one for me and one for herThenThe next time we went out, my truck did an acrobatic flip and ALL 4 WENT FLYING....couldnt find a single one.....PLEASE read the other reviews for installation......making the hole a little small is fine.....it can be a challenge pushing the grommets thru the hole, but if it fits tight, IT STAYS.If you are thinking whether you should or not.....DO IT....GLAD I DID

Easy to install on an 18 year old E-maxx and brand new Redcat Shredder. Had to drill a little larger than 5/16 hole but fit perfect. Once those clips are in there they are good and tight. Love that I don't have to set the clips down on the ground anymore when I swap out batteries. Would buy again. A must have and so simple in concept.

Easy to install. Stay put and nub does not pop out if installed properly (use correct drill size). Durable, been using for a few months without issue. Comes with large clips, straps will hold smaller clips as well.

It's my son's truck but I probably drive it more than he does. :-)This seems to be a pretty good solution to the problem of losing clips. There is no way a clip is going to come out without it being on purpose. I think the purpose of these is more to prevent you from losing the clip when you're in the field/woods/gravel banks, and you purposely pull the bodywork off, rather than preventing them from coming off while you're driving.They were a little bit of a challenge to install because you want to make sure you don't drill the hole in the body too big or the holder will just pull right out. I have a great pair of super skinny needle-nosed pliers that I used to poke the rubber holder through the hole in the bodywork but it was still difficult. But the harder it is to get in, the harder it will be for it to fall out, so it was worth it!

Drilled a 5/32 hole in my truck and boom works like magic so far didn’t lose a clip

These are excellent quality. The clips are good and strong too.

Looks very nice on my RC car with very fast shipping and service thank you.

perfecto para retener los clips, muy buen material y van mas allá con clips adicionales por si necesitas otras medidas